Shardik

On 8/19/2021 at 5:55 AM, zaphod said:

A used 4 zone Control4 matrix amp from eBay would be another option.

Nice I was looking at those. Do you know if they all work with OS3?

On 8/18/2021 at 10:16 PM, booch said:

Jamo JDA500 DSP? I have a bunch of the Klipsch versions (same hardware AFAIK) and they do well. Think you can pick one up just under $500. Theres a driver too (not that it’s needed).

If you need more than pure amplification (can’t tell), you could pick up a late model Sonos on eBay, I’d assume.

Thank you I will check that out

1 hour ago, Control4Savant said:

Are your speaker points local to other Control4 AV gear? What types of wire do you have at these locations? Inexpensive for possibly centralized music and audio streaming and two zone amplification is subjective so a budget would be helpful. 

They are located right by the controller. I’d like to stay below $500 if possible. 

Hello I need to replace 2 speaker points to get on OS3. It can be one 2 zone amp. Looking for a decent inexpensive solution. Thanks!

Really excited to have found Ari. He was responsive, quick to complete the job, and didn't waste any of my time. 

Ok this is weird. It was actually my HC-800 running director that won't ping. It shows online in Fing, and everything else C4 seems to be working fine.

23 minutes ago, andypaul said:

Any changes that you or a tech made that may have triggered an issue?

The Alarm will report a problem if it is not communicating with the network if it is not retorting a problem then the TL280 receiver may have been disabled.

The TL280 has Communicator Status LED's that indicate error situations have a look at these and correlate them to the TL280 manual. 

I have had the following issues previously:

- Electrician wired a data cable 1 is to 1 as in not to T568A or T568B spec the TL280 didn't like this

- Alarm tech wired the ribbon cable to the TL280 from the main alarm board inverted

- The TL280 receiver board was disabled in the Alarm setup

- Change of any of the Installation Info in the TL280 Control 4 Driver

- Change in the IP Subnet while the TL280 has a Static IP Address

Hope this helps.

Thanks! I haven't had anyone working on it, but I will check the IP.

3 minutes ago, andypaul said:

Shardik - Was it working previously?

Yes it was. It stopped working about a month ago.

I can't seem to connect to my TL280. I can't even ping it, but I have checked that the ethernet cable running to it is getting signal to it. Anyone have any ideas on what I could do?

thanks

Does the communicator have to be by the panel? I'm thinking of getting one of these, but I don't have ethernet to my panel.