smarch Posted August 23, 2011 Share Posted August 23, 2011 Please bare with me on this one. I have several 3 way switch scenarios in my house, which I installed and work perfectly. This particular scenario I can't seem to get working. I have a feeling it's easy, but I'm just not seeing it. This is what I have:Dimmer location: 1 x wire Power in (Black White, ground), 1 x wire to 3 way switch which I'm using a 3 button key pad (White Red Black), 1 x wire to light (black white)3 button keypad location 1 x wire consisting of (White, Black and red) coming from dimmer location.Any help with what connects where would be appreciated. I have the 3 way diagram that I downloaded from this site, but it's not helping.Thanks againScott Link to comment Share on other sites More sharing options...
ILoveC4 Posted August 23, 2011 Share Posted August 23, 2011 Just hook up hot neutral and ground to the keypad. Link to comment Share on other sites More sharing options...
smarch Posted August 23, 2011 Author Share Posted August 23, 2011 Hi againNot sure if I was clear. This is the wiring I have, I need to know how to connect all of it.Box 1 wire 1 - white, black and red wire 2 - white and black (mains i.e. the power from the breaker) wire 3 - white and black (load i.e. the light)Box 2 wire 1 - white, black and redThe dimmer will be in Box 1, and the 3 button keypad in Box 2.Thanks Link to comment Share on other sites More sharing options...
ILoveC4 Posted August 23, 2011 Share Posted August 23, 2011 On the 3 button keypad hook up black and white. You don't need the red wire on either end. Link to comment Share on other sites More sharing options...
smarch Posted August 23, 2011 Author Share Posted August 23, 2011 ok thanksHow about the dimmer side? Link to comment Share on other sites More sharing options...
Godzilla Posted August 23, 2011 Share Posted August 23, 2011 might want to try it this way:in box #1 you will need to make sure you tie all the white wires together/ and tail to the dimmer..........then tie all the grounds together/ then tail to the dimmer...............now tie the black wire from the light to the load tail on the dimmer............now tie the black wire from panel (feed) to the black wire from box#2 and tail to dimmer.................cap off red wire on both ends.then in box #2 do as ilovec4 saysthe reason i did a step by step is you have a dead end 3-way ...........so the electrician could have used the white and red as travelers or the black and red........cant tell from here Link to comment Share on other sites More sharing options...
smarch Posted August 23, 2011 Author Share Posted August 23, 2011 Thanks very much everyone. Got it figured out!! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.