Neter66 Posted April 23, 2011 Share Posted April 23, 2011 I've built a new house, and wired it myself for automation ( 75 switches / dimmers ), 2x HC300c controllers, control4 amp and speakers throughout the house, PoE cameras, and cat6 throughout. I ran a cat6 wire from the front door to the rack, planning to use it as the doorbell. However, I forgot to run a cable to an actuall sounder for the doorbell. Now, I'm thinking that I will use the relay in the HC300 and then just play an announcement throughout the house when the doorbell is pressed. Question is: is this viable? Do I need anything else? I'm assuming I can just wire as normally open, and then fire the event when closed. Thanks in advance. D. Link to comment Share on other sites More sharing options...
Godzilla Posted April 23, 2011 Share Posted April 23, 2011 You will need to hook it up to the contact-----on the hc300-----------------not the relay----------------and yes it will work----------------------if it is a lighted pushbutton---you will need card access doorbell module. Link to comment Share on other sites More sharing options...
NkySpike65 Posted April 23, 2011 Share Posted April 23, 2011 If you use a lighted door bell, you will need to use the Elk 930 DoorBell unit with your controller... The Elk unit will still give you power to light the door bell, and let the controller's contact work together with the door bell.The kit comes with two door bell circuits, marked A and B. Plus it has a telephone unit too, they all come attached on one circuit board, you just "snap" the units apart to separate. http://www.google.com/#q=elk+doorbell+detector&hl=en&prmd=ivns&source=univ&tbm=shop&tbo=u&sa=X&ei=kRyzTbXbKdCgtweuq5XqDg&ved=0CDYQrQQ&biw=981&bih=661&bav=on.2,or.r_gc.r_pw.&fp=e24313f026a8d8c9 Good Luck, David Link to comment Share on other sites More sharing options...
ILoveC4 Posted April 23, 2011 Share Posted April 23, 2011 I use the Elk unit and like it. Link to comment Share on other sites More sharing options...
Neter66 Posted April 24, 2011 Author Share Posted April 24, 2011 Thanks folks. The boss wants a simple round doorbell, no light, so the wire to the contact on the HC300 appears to be the route I'll take. Thanks again,D. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.