R_Willis Posted October 22, 2010 Share Posted October 22, 2010 Can't get to reidentify. It's been in the project before.The LEDs are blinking red, green, and amber continously. Don't stop.I've tried holding the button down when removing power, to reset. But, it doesn't do anything.Any ideas? Link to comment Share on other sites More sharing options...
henniae Posted October 22, 2010 Share Posted October 22, 2010 What version of system software is the project? Did you recently upgrade? Is the project ZigBee Pro and perhaps the contact switch Embernet? Link to comment Share on other sites More sharing options...
R_Willis Posted October 22, 2010 Author Share Posted October 22, 2010 1.7.4.xxxDid recently upgrade from 1.7.1.xxx or something.NON zigbee pro device and project. Link to comment Share on other sites More sharing options...
Garp Posted November 11, 2010 Share Posted November 11, 2010 CI've tried holding the button down when removing power, to reset. But, it doesn't do anything.Any ideas?That's not how you reset those. Hold the ID button down, add power, then release the ID button as soon as you see the Yellow LED.G Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.