Control 4 and KNX Secure

[Stephan]

Hello,

I have my system running with Control 4 and KNX. Unfortunately, when I switch on KNX Secure, I can no longer connect Control 4 to the KNX router. Is it possible that Control 4 cannot establish a connection to the router with the KNX gateway driver if secure is switched on?

best Regards

Stephan

 

[Kaas Mayer]

did you enable knx secure on the knx routing driver within composer?

did you pass also secure group addresses to the network? (setting in ETS)

[Stephan]

Hi,

Yes, I have switched on KNX Secure but the question is what is the KNX IP Backbone Key or what do I have to enter there?

I have deactivated all the filters in the KNX router and everything should go through as far as traffic is concerned. I don't have any other settings. The router is a Siemens KNX IP Router N146/03

If I turn off secure it works without problems but since I have KNX RF in the KNX Line I wanted to use Secure

Best Regards

Stephan