Nupe1911 Posted October 15, 2021 Share Posted October 15, 2021 Any suggestions, will not connect. I have tried unplugging and resetting my router. Flashing .mov Quote Link to comment Share on other sites More sharing options...
mujtaba.khokhar Posted October 15, 2021 Share Posted October 15, 2021 Which processor do you have? If your system wasn’t being updated, it’s likely your project has been corrupted and the processor is failing to boot and stuck in a boot loop. the flashing lights indicates a factory restore is happening. I’ve had processors do this in the past and they’ve needed to be replaced / Rma’d. you could try a network reset. To reset the controller network settings to the default: 1 Disconnect power to the controller. 2 While pressing and holding the ID button on the back of the controller, reconnect power to the controller. 3 Hold the ID button until the data, link and power LEDs are solid blue, then immediately release the button. 4 If the caution LED stays orange during the boot sequence, press and hold the ID button until the caution LED blinks blue, and then release it. Thanks Muj Quote Link to comment Share on other sites More sharing options...
Nupe1911 Posted October 15, 2021 Author Share Posted October 15, 2021 25 minutes ago, mujtaba.khokhar said: Which processor do you have? If your system wasn’t being updated, it’s likely your project has been corrupted and the processor is failing to boot and stuck in a boot loop. the flashing lights indicates a factory restore is happening. I’ve had processors do this in the past and they’ve needed to be replaced / Rma’d. you could try a network reset. To reset the controller network settings to the default: 1 Disconnect power to the controller. 2 While pressing and holding the ID button on the back of the controller, reconnect power to the controller. 3 Hold the ID button until the data, link and power LEDs are solid blue, then immediately release the button. 4 If the caution LED stays orange during the boot sequence, press and hold the ID button until the caution LED blinks blue, and then release it. Thanks Muj Sadly, still flashing Red. I have a C4-EA3.....how much does a replacement cost? Quote Link to comment Share on other sites More sharing options...
mujtaba.khokhar Posted October 16, 2021 Share Posted October 16, 2021 Where are you located? Quote Link to comment Share on other sites More sharing options...
Nupe1911 Posted October 16, 2021 Author Share Posted October 16, 2021 1 hour ago, mujtaba.khokhar said: Where are you located? Indianapolis Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.