Just want to check something. With a dry contact the manual says to use 12+ and Sig for a dry contact (simple open close). I am using those connections and the binding is to the right contact sensor.
I have done the following:
Tested opening and closing the gate - sensors are perfectly aligned. - Stays closed if I pull the contacts apart stays closed.
Replaced the dry contact - same as above (outcome)
Tested swapping 12+ and SIG incase I got the wiring wrong way round same as point 1 (outcome)
Tested continuity on each wire making sure the wire is not broken somewhere - there is continuity
It is quite a long run of wire normal thin single core alarm type wire.
Question
ILoveControl
Hi all,
Just want to check something. With a dry contact the manual says to use 12+ and Sig for a dry contact (simple open close). I am using those connections and the binding is to the right contact sensor.
I have done the following:
It is quite a long run of wire normal thin single core alarm type wire.
Have I missed something here?
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.