Bullseye Posted December 22, 2016 Share Posted December 22, 2016 I have a led in 2 keypads that when the garage door is open turns to green and when I close the door they turn to black again. I am trying to do the same with the front door, but when the door opens the led does change color but when the door closes it don't go back to black. The open/close signal comes from the alarm system (vista 20p with 4232 module) I checked the garage door programing and it only uses 1 line of programming. What is wrong?? Link to comment Share on other sites More sharing options...
msgreenf Posted December 22, 2016 Share Posted December 22, 2016 hard to say what is wrong without seeing what you are doing....I do similar things in my house... Link to comment Share on other sites More sharing options...
knowitall Posted December 22, 2016 Share Posted December 22, 2016 May be a polling issue or an issue if you have both doors open at the same time. Or one opens and closes while the other is just open. Link to comment Share on other sites More sharing options...
msgreenf Posted December 22, 2016 Share Posted December 22, 2016 1 minute ago, knowitall said: an issue if you have both doors open at the same time. should not be an issue with this driver and module Link to comment Share on other sites More sharing options...
knowitall Posted December 22, 2016 Share Posted December 22, 2016 It could if the programming is when door opens/closes change the light colors. C4 follow last command Link to comment Share on other sites More sharing options...
Bullseye Posted December 22, 2016 Author Share Posted December 22, 2016 This is the garage door programing and it works Link to comment Share on other sites More sharing options...
Bullseye Posted December 22, 2016 Author Share Posted December 22, 2016 This is the front door and the led changes, but stays on Link to comment Share on other sites More sharing options...
msgreenf Posted December 22, 2016 Share Posted December 22, 2016 hat is your code for when the door closes? Link to comment Share on other sites More sharing options...
Bullseye Posted December 22, 2016 Author Share Posted December 22, 2016 Got it!!! I didn't realize there was programing with the closing. Thanks!!! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.