abeasst Posted December 24, 2012 Share Posted December 24, 2012 How can I go about monitoring the CO2 pressure of the CO2 bottle in my kegerator. I want to get a notification if it drops below a certain pressure. I've already got a contact sensor monitoring the temperature of the kegerator. Link to comment Share on other sites More sharing options...
wingzz Posted December 24, 2012 Share Posted December 24, 2012 use a pressure switch, wired into a contact switch Link to comment Share on other sites More sharing options...
sevendustweb Posted December 24, 2012 Share Posted December 24, 2012 How can I go about monitoring the CO2 pressure of the CO2 bottle in my kegerator. I want to get a notification if it drops below a certain pressure. I've already got a contact sensor monitoring the temperature of the kegerator.Please let me know if you get this working. This would be awesome. Link to comment Share on other sites More sharing options...
C4RVA Posted January 16, 2013 Share Posted January 16, 2013 I had a kegerator that used an analog pressure sensor connected to a basic stamp micro controller. You could integrate that via rs 232 to c4. This would require a large amount of effort to integrate. Link to comment Share on other sites More sharing options...
CFUG Posted January 16, 2013 Share Posted January 16, 2013 ^Wow, talk about taking the long way around... Hobbs pressure switch connected to either a CA device or directly to a HC. Link to comment Share on other sites More sharing options...
C4RVA Posted January 18, 2013 Share Posted January 18, 2013 A pressure switch only gives you an on or off reading depending on what pressure the switch activates. My setup senses the actual pressure in psi and can pass that information to a c4 controller. Think on a light switch versus a light dimmer. Link to comment Share on other sites More sharing options...
wingzz Posted January 18, 2013 Share Posted January 18, 2013 well per what the OP was asking for " I want to get a notification if it drops below a certain pressure" a pressure switch will work perfectly and much easier to set up Link to comment Share on other sites More sharing options...
CFUG Posted January 18, 2013 Share Posted January 18, 2013 A pressure switch only gives you an on or off reading depending on what pressure the switch activates. My setup senses the actual pressure in psi and can pass that information to a c4 controller. Think on a light switch versus a light dimmer.Different strokes for different folks... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.